SS-1.1 Application Standards
.1
ARCA members consider what constitutes the
essential roofing practices which must be carried out for a
steep-slope roofing system to provide an acceptance service life in
Alberta. These essential practices are referred to as application
standards and are the basis for the issuance of the Warranty
Certificate.
.2
The designer should specify the issuance of the
Warranty Certificate to insure that the steep-slope roofing
application standards are met.
.3
Due to the complexity and possible combinations
of construction, not every situation can be covered by the
application standards. ARCA administration is authorized to rule,
upon written application, on situations or conditions not
specifically covered by the application standards.
SS-1.2 Warranty Certificate
.1
The ARCA Warranty Ltd. Warranty Certificate (WC)
is a joint undertaking by the ARCA Contractor member and the ARCA
Warranty Ltd. which assures the owner of the following:
-
The completed roofing system is comprised of ARCA Warranty Ltd. accepted materials proven to perform in Alberta.
-
An ARCA professional Roofing Contractor has supervised completion of the roof installation.
-
The workmanship meets ARCA Warranty Ltd. application standards.
-
The completed steep-slope system is inspected by an ARCA Warranty Ltd. accepted independent roofing inspector for issuance of the WC.
-
Any workmanship related leaks, which are the responsibility of the Contractor, occurring within the first two years of warranty term, will be repaired at no additional cost to the owner.
-
In the event that a member contractor defaults on the warranty, for any reason, ARCA Warranty Ltd. will assure their responsibility and liability for the remainder of the warranty period.
SS-1.3 Effective Date of the Warranty Certificate
.1
The effective date for the Warranty Certificate
is the date of final inspection by the accepted independent roofing
inspector.
.2
Any deficiencies noted on the final inspection
report will be rectified prior to the issuance of the warranty
document.
.3
If deficiencies are found which are the
responsibility of others and which affect the roofing system, the
certificate may be issued with a covering letter to the owner
outlining the limitations of the certificate (because of such
deficiencies) or no certificate will be issued until written
confirmation has been received that the deficiencies have been
corrected by others.
.4
The designer/owner may wish to have the
effective date of the WC coincide with the completion date for
their project.
.5
Should the completed roofing system be in
service for more than three (3) months after application then the
following provisions must be undertaken prior to warranty
issuance.
-
The entire roofing system shall be inspected and a post final inspection report must received from an ARCA Warranty Ltd. accepted independent roofing inspector and the cost borne by others.
-
Any damage or deficiencies found during the post final inspection must be corrected by the original ARCA contractor and the repair cost borne by others.
SS-1.4 Requirements for the Issuance of the Warranty Certificate
.1
A Steep-Slope Roofing Warranty Certificate will
be issued only when the following conditions have been met:
-
The roofing contractor is a member in good standing with ARCA.
-
All roofing has been applied under the on-site supervision of a journeyman roofing or sheet metal mechanic employed by a member contractor.
-
The roofing system has been constructed with the Province of Alberta.
-
The steep-slope roofing system is one which has been accepted by ARCA Warranty Ltd.
-
The application standards outlined in Part 3, Steep-Slope Roofing as well as any other specific specifications which the designer may incorporate which are not inconsistent with the application standards have been adhered to.
-
The construction of the steep-slope roofing system has been inspected by an ARCA Warranty Ltd. accepted independent roofing inspector and,
-
The structure on which the roofing system is installed has been permanently affixed to its building site at the time of installation
SS-1.5 Warranty Certificate Term
.1
A five (5) year warranty certificate is
available for commercial and residential steep-slope and
architectural standing seam metal roofing.
Added
2009-08-18