ARCA logo

Serving Alberta's Roofing Industry Since 1961

ARCA logo

BUR Section 1: Roof Decks

BUR-1.1 General

.1

The roof deck provides the structural support for the roofing system. Roof decks shall be designed in accordance with the Alberta Building Code to support design and construction loading.

.2

The surface of roof decks must be sufficiently clean, dry and sound to receive roofing materials, so proper adhesion and attachment may take place.

.3

Where electrical conduits, fittings, bolts and plates project above the deck surface, a smooth substrate plane shall be provided to receive roofing materials. Correction to the substrate plane in the proximity of the projections must be addressed on an individual project basis.

.4

Roof deck perimeters shall be structurally supported. Deck openings require additional structural framing to support and to prevent excess deflection of the surrounding decking.

BUR-1.2 Wood Decks

BUR-1.2.1 Dimensioned Lumber Decks

.1

Dimensioned lumber decks may be constructed from sawn lumber, planks or ship lapped boards.

.2

The direct mopping of hot bitumen adhered BUR membranes to dimensioned lumber decks is not permitted.

.3

For uninsulated and protected membrane design BUR roofing systems, a mechanically fastened auxiliary leveling surface must completely cover a dimensioned lumber deck.

.4

For conventional insulated BUR roofing systems, the vapour retarder shall be mechanically fastened to the wood decking.

BUR-1.2.2 Sheathing Decks

.1

Plywood and oriented strand board (O.S.B.) sheathing shall be manufactured for exterior application.

.2

The direct mopping of asphalt adhered BUR membranes to sheathing decks is not permitted.

BUR-1.3 Concrete Decks

.1

Cast-in-place and pre-cast concrete decks shall have a smooth dry surface and shall be adequately cured prior to BUR application.

.2

Pre-cast concrete deck grout keys shall be grout filled.

.3

The maximum differential height permitted without correction between pre-cast concrete deck members is 6.4mm (1/4"). Height differences greater than 6.4mm (1/4") but no larger than 19.0mm (3/4") shall be corrected using cementitious grout or fill feathered to a maximum slope of 1:50 (1/4"/ft). When height differences exceed 19.0mm (3/4"), a topping coat shall be applied to correct the deck surface.

.4

Above deck projections such as anchor bolts and plates shall be feather grouted to provide a smooth roofing substrate.

.5

Hot bitumen may be used to adhere BUR membranes directly to concrete decks.

BUR-1.4 Steel Decks

.1

Steel deck flutes shall be reasonably free of snow, ice and debris, prior to BUR application.

.2

Unsupported deck openings are restricted to a maximum dimension of 200mm (8").

BUR-1.5 Stramit Decks

.1

Stramit is a structural and/or insulating panel manufactured from straw fibre in 50mm (2") or 64mm (2 1/2") thickness as roof deck and/or insulation.

.2

Prior to re-roofing over stramit decks, ARCA Administration must be notified of the existing structural condition of the stramit decking.

BUR-1.6 Deck Fills

.1

Water based cementitious insulating fills comprised of mixtures of cement/gypsum and insulation/vermiculite are not accepted decks for Warranty Certificate issuance.

.2

Bituminous deck fills comprised of bitumen and vermiculite are accepted for Warranty Certificate issuance.

.3

The finished surface of bituminous deck fills shall be smooth and uniform.